What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 22.06.2025 11:57

He then describes Rainy Season and Lightning.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
What does a fuse do?
How do flat Earthers explain the existence of other spherical planets?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
It also is a device that limits the change in current flow.
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is where this question deviates from being a 'generic' question, and becomes more specific.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This one hit behind the barn.
Do conservative white women like black men?
The other is “what does a “fuse” do?”
These are simplified answers to the original question, and does not change anything I wrote above.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Drug deaths plummet among young Americans as fentanyl carnage eases - NPR
At one ohm, the resistor has a maximum of 1 watt power.
In schematic diagrams this is the symbol for a fuse:
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Were any US Generals hurt or killed yesterday in Damascus, Syria, yesterday 5/9/24?
One
so, what happens?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
This Chinese Spacecraft Is Traveling to One of Earth’s Quasi-Moons - WIRED
Because the load is inductive, the current lags the voltage.(by a bit).
There are two important concepts here.
Here is a simplified AC power diagram.
Democrats be honest, how many of you were wishing that Musk rescue space flight blew up?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Barnstars:
Edit 2024–10.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
[old diagram got deleted by accident]
nine
What makes cars from companies like Dacia or BYD appealing compared to Tesla, especially in Europe?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–10–16 [ OO OLAOYE OYEBODE ]
what exactly is a ‘surge’ protector?
How likely do TWS earbuds explode these days? I'm still using wired earbud because I'm paranoid.
Upvotes:
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Does Taylor Swift actually play the guitar, or is it a prop?
He then describes the function of a fuse.
A fuse is a non-resetable over current circuit protector.
but this device (an Inductor) … impedes the rapid changes in the current.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
(Dc diagram shown, AC is similar).
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
But… the neutral is now “floating” because of the 1 ohm resistance.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
It seems Mohan does not understand the difference between a comment and an Answer.
I post the exact comment here.
[image of Common-mode choke]
One is “what exactly is in a ‘surge protector’ ? ”
eight
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
He then asserts :
What is lightning?
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
The third is lightning and “how it gets conducted into a home.”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
An AC voltage/ current source, and an ac inductive load.
This is where the MOV conducts again, and dissipated the energy.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
But it can get overloaded, and no longer works.
These devices are installed between the “hot” and “neutral” and protective ground.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
So, the voltage could go up to 500 volts, and the fuse will not open up.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
a photo is worth a thousand words.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
A circuit breaker is similar, but is resettable.
The bolt then partially travels down the line to your home.
but I think this circuit , shows a few more pieces.
2024–10–10[John johnson John Johnson ]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
For this case there are devices called Metal oxide varistors (MOV).
This device then solves the entire problem.
At least they know the answer if they wanted it.
This is 'the assistant's answer'
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
the problem then depends on "how fast does the fuse operate?".
There are three different concepts here that are getting confused.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
First Sentence: